Blar i Scientific Publications in Engineering Sciences på tittel
Viser treff 405-424 av 702
-
Model reduction of fuzzy logic systems
(Journal article; Peer reviewed, 2014)This paper deals with the problem of l 2 - l ∞ model reduction for continuous-time nonlinear uncertain systems. The approach of the construction of a reduced-order model is presented for high-order nonlinear uncertain ... -
Model test of a dual-spar floating wind farm in regular waves
(Chapter, 2023)A floating wind farm with shared moorings has the potential to reduce capital expenditure but may face structural dynamics issues. We selected a prototype wind farm that consists of two spar floating wind turbines with ... -
Model-based development for MAC protocols in industrial wireless sensor networks
(Journal article; Peer reviewed, 2016)Model-Driven Software Engineering (MDSE) is an approach for design and implementation of software applications, that can be applied across multiple domains. The advantages include rapid prototyping and implementation, along ... -
Model-based verification of the DMAMAC protocol for real-time process control
(Journal article; Peer reviewed, 2015)Medium Access Control (MAC) protocols are responsible for managing radio communication that constitute the main energy consumer in wireless sensor-actuator networks. The Dual-Mode Adaptive MAC (DMAMAC) protocol is a recently ... -
Model-Free Sliding-Mode-Based Detection and Estimation of Backlash in Drives With Single Encoder
(Journal article; Peer reviewed, 2019) -
Modeling and backstepping control of the electronic throttle system
(Journal article; Peer reviewed, 2013)Electronic throttle is widely used in modern automotive engines. An electronic throttle system regulates the throttle plate angle by using a DC servo motor to adjust the inlet airflow rate of an internal combustion engine. ... -
Modeling and field-experiments identification of vertical dynamics of vehicle with active anti-roll bar
(Chapter, 2020)This paper deals with modeling and identification of vertical dynamics of the ground vehicle equipped with two active anti-roll torsion bars. A series of field tests of a full-scale drive have been performed, from which ... -
Modeling and simulation of a High Pressure Roller Crusher for silicon carbide production
(Chapter; Peer reviewed, 2011)This paper describes the modeling and simulation of High Pressure Roller Crusher (HPRC) for the production of silicon cabide grains. The study is to make a model for simulation of a High Pressure Roller Crusher. A High ... -
Modeling and simulation of an offshore crane
(Chapter; Peer reviewed, 2018) -
Modeling asteroid binary systems with the full two-body problem using surface integrals
(Doctoral Dissertations at the University of Agder; no. 432, Doctoral thesis, 2023)An asteroid binary system, where two asteroids are in mutual orbit, is important to study as it can provide knowledge of the history of the asteroid population. The most important mechanism to form asteroid binaries in the ... -
Modeling of a Shared Mooring System for a Dual-Spar Configuration
(Chapter; Peer reviewed, 2020) -
Modeling of an active torsion bar automotive suspension for ride comfort and energy analysis in standard road profiles
(Journal article; Peer reviewed, 2019) -
Modeling of Modified Vehicle Crashworthiness using a Double Compound Pendulum
(Chapter; Peer reviewed, 2022)Vehicle crash modeling has been a challenge for researchers for several decades. Occupant injury prevention and prediction is a critical area within vehicle safety design. The modeling of material failure in structural ... -
Modeling of the Thermal Efficiency of a Whole Cement Clinker Calcination System and Its Application
(Peer reviewed; Journal article, 2020) -
Modeling Stator Winding Inter-Turn Short Circuit Faults in PMSMs including Cross Effects
(Chapter; Peer reviewed, 2020)This paper presents a detailed analysis of stator winding inter-turn Short Circuit (ITSC) faults, taking the cross effects in the three phases of a permanent magnet synchronous motor (PMSM) into account by considering ... -
Modeling, simulation and design optimization of a hoisting rig active heave compensation system
(Journal article; Peer reviewed, 2013)The objective of this paper is to present an approach in developing a virtual active heave compensation system for a draw-works on a hoisting rig. A virtual system enables quicker overall product development time of a ... -
Modelling of a hydro-pneumatic system for heave compensation
(Chapter; Peer reviewed, 2018) -
Modelling of Photovoltaic Modules with Battery Energy Storage in Simulink/Matlab With In-SituMeasurement Comparisons
(Chapter; Peer reviewed, 2014) -
Moisture induced degradation in field-aged multicrystalline silicon photovoltaic modules
(Peer reviewed; Journal article, 2023)Moisture ingress is one of the key fault mechanisms responsible for photovoltaic (PV) devices degradation. Understanding moisture induced degradation (MID) mechanisms in field-aged PV modules is more reflective of the ... -
Moisture ingress in photovoltaic modules: A review
(Peer reviewed; Journal article, 2021)Moisture ingress in photovoltaic (PV) modules is the core of most degradation mechanisms that lead to PV module power degradation. Moisture in EVA encapsulant can lead to metal grids corrosion, delamination and discolouration ...