Blar i Faculty of Engineering and Science på emneord "ENE500"
Viser treff 41-60 av 76
-
Measurements and analysis of spectral irradiance distributions in southern Norway
(Master thesis, 2018)The spectral response of the photovoltaic (PV) cell depends on which technology that is used and the outdoor performance of PV modules depends on solar irradiation, module temperature, and solar spectrum. Therefore, di ... -
Measurements of magnetic flux density in rotating machines : development of a calibrated and portable measurement system
(Master thesis, 2014)Diagnostics of generator poles has traditionally been done by measuring the impedancein each pole and assume that the magnetic ux density is proportional to the impedance.With Hall-sensors it is possible to measure the ... -
Modeling and Forecasting the Nord Pool Day-Ahead Power Market through Deep-Learning
(Master thesis, 2017) -
Modelling and simulation of BIPV installations in Norway
(Master thesis, 2018)In this thesis, three BIPV-installations has been simulated, the simulated results of each system have been compared to actual production for the real system. The parameters which are assessed in this thesis are production, ... -
Optimization of Charging Stations on a Route with Electric Buses
(Master thesis, 2019)This studyconsiders placement of electric charging stations for a public electric bus system with the intention of minimizing the charging power. This is an optimization problem where fully electric buses with opportunity ... -
Optimization of multi-reservoirpumped-storage hydropower system using differential evolution
(Master thesis, 2019)The study has proposed a long-term optimization model of a multi-reservoirpumped-storage hydropower system which is located in the Aust-Agder region.Based on the requirement a pump has been installed at a particular site ... -
Optimization of Power Supply for Hydrology-and Meteorology-stations : Optimization of power supply for off-grid hydrology- and meteorology-stationsusing machine learning and genetic algorithm
(Master thesis, 2019)This thesis consider a case study of a PV/wind/battery hybrid energy system installed at Scanmatic ASheadquarters in Arendal, Norway. The energy system is a stand-alone and off-grid hybrid system. It consistof four PV ... -
Optimization of Wind Farm Layout taking Load Constraints into Account
(Master thesis, 2017)Optimization of a wind farm layout is of utmost importance due its economical aspect. The primary aim of optimizing layout is to increase the overall energy production. The higher energy production creates more revenue ... -
PEM Fuel Cell System : A practical approach for building, testing and controlling a self designed PEMFC stack
(Master thesis, 2017)Fuel cells are an effcient way to produce electricity, especially if it is combined with heat pro- duction. If designed to consume hydrogen, like PEMCF, the only byproduct is water in its purest form H2O. This would have ... -
Performance Degradation and Failure Analysis of 7 Years (of) Field Exposed Photovoltaic System in Southern Norway
(Master thesis, 2018)This thesis covers an analysis of performance degradation and failure detection of thin-film (Sharp) and m-Si (REC and Suntech) PV modules located at Kjøita in the south of Norway. The analysis consists of performance ... -
Photovoltaic facade systems in Norway: An assessment of energy performance, building integration, and costs
(Master thesis, 2018)In this master thesis, different PV facade systems located in Norway have been evaluated and analyzed. It will thus contribute to the ongoing development of a national database of BIPV. Also, technical and economic aspects ... -
Photovoltaic production for a fixed tilt plane, with different surface azimuth angles. Analyzing system operating conditions and time of day production
(Master thesis, 2019)Photovoltaicsystems for residential household may bea large part of energy production in the future. The electric grid is facing challenges,andphotovoltaicsystems can contribute in the reduction of electricgrid ... -
Planning of Residential Microgrid Community with Technical and Economic Analysis
(Master thesis, 2018)Establishment of microgrid communities in Norway can contribute to solve many upgrading challenges of the existing grid. Today's grid are in many areas not suited to handle both bidirec- tional power ow and the increasing ... -
Power Prediction of Photovoltaic System using Neural Network Models
(Master thesis, 2019)This workconsidersa photovoltaic (PV)system installed on the rooftop of Agder Energi’s headquarters located at Kjøita, Kristiansand. The system includes three different types of solar PV modules; Suntech (multi-Si), Sharp ... -
Production and Characterisation of Durable Biochar Briquettes Designed for Metallurgical Industry
(Master thesis, 2021)Available from 01/07/2026 -
Prognosis of ball bearings with non-characteristic degradation using recurrent neural network
(Master thesis, 2019)Breakdowns in rotary machines are often related to bearing failure. In recentyears many prognostic and diagnostic models of bearings have been developedto prevent unexpected shutdowns. Estimating the remaining useful ... -
Proper sizing of energy storage for grid connected photovoltaic system
(Master thesis, 2014)The requirement of an energy storage to a grid connected PV system, is highly desirable in cases like power outages. Another importance is to reduce the peak time electricity buying from the utility grid and discharging ... -
PSIM-Based Hardware and Software Design of an Inverter-Fed Permanent Magnet Synchronous Motor
(Master thesis, 2018)The purpose of this research is to design a PSIM based controller for an inverter-fed Permanent Magnet Synchronous Motor (PMSM). The dimensioning and assembly of the controller are presented. The control algorithm used ... -
Sensorless Control of Induction Motors Using an Extended Kalman Filter and Linear Quadratic Tracking
(Master thesis, 2017)Conventional sensorless controls for induction motors require two PID regulators and precise gain turning. This thesis presents a sensorless control for induction motors using an extended Kalman filter (EKF) and linear ...